Occasionally, needle-nose pliers or another tool will be necessary to grasp a very small piece of wick and pull it through the hole. This should provide enough relief to squeeze the wick into the hole. Once you’ve got it as skinny as you can on one end, then take a sharp pair of utility scissors and cut the frayed fibers off and shape that end of the wick into a “V”. If the hole seems too tight, then use the wire in the wick to twist the wick tighter and longer and narrower.
#RONSON LIGHTER WICKS INSTALL#
Most times, with the insert clean and free of build-up or grime around the hole the wick is intended for, a stiff wick can be placed at the hole and with a gentle and constant pressured twist will install fairly easily. I always use the wicks with the copper wire woven through them when rewicking insert type lighters. I don’t usually follow this step unless I feel pretty strongly the lighter was contaminated but this is not a difficult step to accomplish and there have been a few occasions where after replacing the wick and wadding, the lighter still wasn’t acting right and I wished I’d have just cleaned it thoroughly while I had the chance. If the wick seemed contaminated with oil or another substance, it might be a good idea to bathe the insert in alcohol or lighter fluid before replacing the wick and repacking the insert. Once all the wadding is removed, the old wick should be easily removed from the insert. Then, using a dental pick or other similar tool, begin to work the rayon or cotton wadding from inside the insert, up and out of it. Be careful to put your flint and spring screw in a safe place so you do not lose them. You will start by removing the flint spring screw which will allow you to pull the felt pad from the bottom of the insert. Zippo, Insert Type Lightersįor the insert type lighters, there’s not much to it.
#RONSON LIGHTER WICKS HOW TO#
With a full length wick you should be able to perform this task several times before needing to actually replace the wick but when the time comes that you do need to replace them, keep reading, I’ve got you covered for how to replace the wick in any petrol lighter. Using a pair of scissors, snip off the old, burnt up part of the wick.Be careful not to pull out too much wick, as you are trying to avoid the entire job of rewicking with this procedure. With a pair of needle-nose pliers, grasp the top of the wick snugly and pull upward.So, if the wick is getting a little short and burnt out looking follow these steps: Most petrol lighters employ a wick that is many times longer than is actually necessary for the function of the lighter. But just so we are all aware, let’s cover a simple trick that can keep you from actually rewicking your lighter more times than not, just like a vape pen will suffice in the absence of a pipe. Your customer is the same way.Ĭhanging the wick in a petrol lighter is not a difficult task, neither is it expensive. Sort of like checking under the hood of an automobile you are interested in buying, you may not know everything but if it looks clean you will probably feel better about the purchase. You might want to change it if you’re going to sell the lighter simply so it looks cleaner. There’s really only one reason you need to change the wick in a petrol lighter and that is it’s not lighting properly in one way or another. While it can seem like a daunting task to the uninitiated, with a little bit of knowledge and a few common tools, just about anyone is capable of rewicking a petrol lighter. Nothing can dampen the thrill of finding a cool old cigarette lighter like a disintegrating or contaminated wick.